Help Easyrelay trafficlights

[iAegle]

So I have to make this trafficlight thingy but I cannot seem to get it working correctly

There's 5 lights, 3 for the car-trafficlight (red green orange) and 2 for the trafficlight that shows if you can cross the road by foot

I have 2 parts which I need to combine but its not working The car-part has to be:
5 sec red >> 5 sec green >> 3 sec orange >> back to red
now when there is someone crossing the road (when the light is green for him) then the car-trafficlight needs to stay red untill the foot-trafficlight goes back to red..

that probably sounds confusing but if someone can help me that would be great

Here's the car-trafficlight part:


and the other part:


I'm not sure if it matters but the easyrelay is a Moeller 700 Series

[Ich1994]

Use this:
http://en.wikipedia.org/wiki/Karnaugh_map

For each light: 1x Green
1x Yllw
1x Red

you need one Karnaugh map.

Model your trafficlight cycle as a finit state maschine.
and then apply the Karnaugh map on it.

[iAegle]

Use this:
http://en.wikipedia.org/wiki/Karnaugh_map

For each light: 1x Green
1x Yllw
1x Red

you need one Karnaugh map.

Model your trafficlight cycle as a finit state maschine.
and then apply the Karnaugh map on it.

I will give it a try, thanks!

[Ich1994]

Use this:
http://en.wikipedia.org/wiki/Karnaugh_map

For each light: 1x Green
1x Yllw
1x Red

you need one Karnaugh map.

Model your trafficlight cycle as a finit state maschine.
and then apply the Karnaugh map on it.

I will give it a try, thanks!

If you need the solution PM me. Or i wont get an Notification e-mail

[iAegle]

The k-map idea was nice but to me it seems quite hard to convert to an actual program.. anyway, I did get it pretty much working

the result if anyone cares: